Impro (Technologies) Europe BV- Identification and Access Control Systems Manufacturer

RSS Subscribe

Close Move

Impro Technologies is a manufacturer of Identification and Access Control systems since 1989. The company manufactures the whole system: tags, cards, readers, controllers and is also writing their own software solutions for a wide variety of applications, including integration of CCTV and burglar alarm systems.

Integration of biometric systems and video recording from 3rd party suppliers is done through the ImproNet Suite, a software solution that combines all the different hardware into one Graphical Interface. A variety of controllers makes it possible to enable communication via TCP/IP, RS232, RS485 and USB, which make the products suitable for applications to a maximum of 3,200 doors.

Single Door Access Control SupaGate

Cost effective Keyless solution for domestic and small commercial application, with a choice from 3 different controllers. Supports 99 tagholders and works with passive tags, PIN codes and/or a 4 channel RF transmitter (Dynamic Code - cannot be copied) with inbuilt passive tag. Models with one relay output, 4 relay outputs and with or without RF receiver. Input for 1 or two readers. No PC interface, manual programming with 4 simple to understand buttons. Can be used with RF tags from various manufacturers.

Single Door Access Control with Multiple Communication Options IXP110

An Access Control system for small commercial applications, where reporting and flexibility of communication is important. Controller available in RS232, USB and TCP/IP version. Supports all Impro antenna readers (metal vandal-resistant, keypad and non-keypad or ABS). Support for 900 tagholders and equipped with storage for 950 transactions when offline from PC. No special software needed for reporting. Reports can be viewed in a standard web browser. Full Anti-Passback with Entry and Exit reader. Remote sites can be managed through dial-up or TCP/IP connectivity. Intrusion alarm systems can be connected too. Works with Impro proximity tags and other standard available 125 kHz tags.

Multi-Site 3-4 Door Access Control System with Multiple Communication Options IXP120

This system can be installed as a single site with 3 doors or 2 doors in full Anti-passback. One database controls up to 10.000 sites. The individual sites can be contacted through TCP/IP, modem, USB, RS232, RS485. Works with all Impro readers, plus a wide variety of 3rd party products by using the 3rd party port for Wiegand, Barcode, Magstripe and Biometric readers. Through this port you can also connect the Impro Mifare reader, the Infrared Receiver and the Impro RF receiver. Readers available in ABS or metal housing. Configuration with IXP120 software. Reporting with standard Web browser. Maximum 2.000 tagholders per site.

1 - 3,200 Door Single To Multi Site Access Control System IXP200- IXP400

This system is specifically meant for commercial/enterprise installations, which are likely to be expanded. The basic system is for maximum 16 doors and comes with a comprehensive software package and inbuilt web interface. Expansion is by means of the ImproNet software suite, which has the capability to expand the system to its maximum of 3,200 doors and 160,000 tagholders with multiple sites linked through a worldwide network. Full integration with CCTV and burglar alarm systems possible. Integration with SAP possible. Inbuilt building graphics module with audible and visual alarm monitoring. On-screen remote control of doors, emergency unlock and tracking a person.

Contact:

Airport Business Park Lijnden
New Yorkstraat 45-47
1175 RD Lijnden
The Netherlands

Tel: +31 20 497 3218
Fax: +31 20 497 3952

Website: www.impro.net

Articles by Impro (Technologies) Europe BV- Identification and Access Control Systems Manufacturer

Access Control Software

Power Supplies

RSS